Hello Guest it is November 23, 2020, 05:08:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - kprice1658

Pages: 1
General Mach Discussion / Elapsed Time indicator
« on: April 07, 2010, 11:39:19 AM »
I just upgraded to the latest Tormach version and noticed that the "Elapsed Time" keeps running when stopped at a tool change, it used to stop with the previous version. I used that to keep track of actual run times on my parts.  I'm not always standing there when it stops for tool change, so I loose that ability to track actual runtimes.  Is this a setting somewhere than can be changed? I asked Tormach and they said they didn't change anything relating to that with their version.


Pages: 1