Topics

1

General Mach Discussion / Torch tip is lowered before it gets to starting point

« on: April 08, 2010, 11:43:35 AM »

In our gcode it tells our torch tip to lower to steel height and then it will move to its first starting point. Then at the end it stays at steel height and moves back to home. Why could this be and how do we change it. If I manually input my z code at the end of cutting it will return home and lift the torch but if I dont it will stay steel height. Any help will be much appreciated.

Thank you

2

General Mach Discussion / Setting up axis home (Newbie)

« on: April 03, 2010, 10:28:20 PM »

Ok we finally got our post processor correct and now our problem is setting the axis home refrences. We can run a picture but when the z axis moves it wants to either run to high on its position or run into the metal. Please help we are so close to running but have stumbled on this step.

Thanks