1
General Mach Discussion / cutting out of line with the toolpath
« on: July 09, 2010, 08:50:09 AM »
I am cutting a design out of 3/16 aluminum in 3 passes. It is a rather intricate design with lots of negative spaces within a circular format about 8 inches in diameter. The first test went beautifully...looking at the piece sideways you could not even tell where the first pass ended and the second started. Now There is a slight step effect caused by the second and third passes not being exactly in line with the first pass. The final outer circular path is way off..(about a quarter inch)...somebody please help! I have 80 to go and have only been able to do one!