1
General Mach Discussion / Initial Speed control issue
« on: May 30, 2014, 08:25:23 AM »
Hi,
Have a lathe with VFD drive running via PWM.
When initially launch Mach3 and after an S command M3 or M4 drive motor at max revs. Reissuing S and then M5 then M3 or M4 bring it back under proper control.
Assume this is a known bug, what is the fix?
Have a lathe with VFD drive running via PWM.
When initially launch Mach3 and after an S command M3 or M4 drive motor at max revs. Reissuing S and then M5 then M3 or M4 bring it back under proper control.
Assume this is a known bug, what is the fix?