1
General Mach Discussion / Z Axis Plunging under power after about 1 hour of running Mach 3 Mill
« on: December 14, 2010, 02:32:18 PM »
I must have missed something in my set up of mach 3, The tool for checking signal noise is saying my signal is OK, I went thru the windows settings and turned all the power saving settings to never. the code runs fine for about 1 hour, and then it plunges, it's done it every time at the 0-0 point on the whichever offset is current. Any help would be greatly appreciated
Thank you,
Chris May
Thank you,
Chris May