1
General Mach Discussion / Mach3Turn rapid speed question
« on: April 03, 2010, 08:11:40 PM »
For some reason my lathe doesn't like G0 rapids? I can replace all G0's with G1's and the code will run OK.
The code has a F12 to set the feed rate. But the rapids still try to go much faster?
Jog works OK - I have the jog set to ~12% to keep the ipm below 12.
The really strange thing is my motor tuning parameters: Velocity - 85, Acc - 20.
How do I get my rapid speed down without changing motor tuning parameters?
Ken
The code has a F12 to set the feed rate. But the rapids still try to go much faster?
Jog works OK - I have the jog set to ~12% to keep the ipm below 12.
The really strange thing is my motor tuning parameters: Velocity - 85, Acc - 20.
How do I get my rapid speed down without changing motor tuning parameters?
Ken