Hello Guest it is February 23, 2020, 06:31:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - silverpuma

Pages: 1
1
General Mach Discussion / Gage Block Height increments oneself
« on: September 24, 2014, 04:27:38 AM »
Hallo
Gage Block Height (in Offset Screen top/left) increments oneself.
The same value can i see in Digitizing Wizard "Width X" !
In Digitizing Wizard i can not enter "Width Y" and "Z travel" the values are overwritten onself.


In other respects my machine works very well since years.
Now i will use the Digitizing Wizard with my new XYZ probe.
I use Version R3.042.038

Could everyone help or give me a idea to isolate the problem ?

best regards :)
 fridolin

Pages: 1