1
General Mach Discussion / mach 3 driver test program
« on: April 08, 2010, 04:21:56 PM »
Hello everyone
I have recently downloaded mach 3 to my tower PC running windows xp (had problems with my laptop running vista)
When running the driver test program, I get to the stage where "system under mach3 control" is dispayed.
The "Pulses per second" dro on top of the display however shows "0", and no horizontal line appears in the "timer variations" window.
The PC is running at 2.6 GHz. Is this too fast for Mach, or should I be looking at a hardware problem with the parallel port.
Any assistance will be greatly appreciated.
Regards
I have recently downloaded mach 3 to my tower PC running windows xp (had problems with my laptop running vista)
When running the driver test program, I get to the stage where "system under mach3 control" is dispayed.
The "Pulses per second" dro on top of the display however shows "0", and no horizontal line appears in the "timer variations" window.
The PC is running at 2.6 GHz. Is this too fast for Mach, or should I be looking at a hardware problem with the parallel port.
Any assistance will be greatly appreciated.
Regards