1
FAQs / Z Axis Double Counting
« on: May 08, 2010, 09:24:24 AM »
Hello,
Wondering if anyone can help. The Z axis on my lathe is double counting in radius mode and quadruple counting in diameter mode. i.e. if I measure the z axis movement 5mm actual, the display reads 10 in radius mode and 20 in diameter mode. The x axis is fine..? This problem just appeared this morning.
I'm a bit new to all of this so I would appreciate any help I can get....!!
Fraser.
Wondering if anyone can help. The Z axis on my lathe is double counting in radius mode and quadruple counting in diameter mode. i.e. if I measure the z axis movement 5mm actual, the display reads 10 in radius mode and 20 in diameter mode. The x axis is fine..? This problem just appeared this morning.
I'm a bit new to all of this so I would appreciate any help I can get....!!
Fraser.