1
General Mach Discussion / Motors not responding
« on: July 30, 2010, 10:56:04 PM »
We had an issue with the x-axis binding when moving towards the positive. After turning off the controler, unmounting the motor and testing the motor and the drive screw (with no iisssuuess found) we re-attached the motor and it bound when traveling in the positive direction only. We concluded that the coupling between the motor and the drive screw was the problem, and shut off the controler then adjusted the coupling. Since that time, none of the motor seem to be working. We have revisited the setup tutorials and also used parmon to see that there is a signal to the serial port...
We are running MAch3 with RockCliff Controler and Motors and an E-stop
We are running MAch3 with RockCliff Controler and Motors and an E-stop