1
General Mach Discussion / Mach and Closed Loop DRO Operation
« on: May 18, 2015, 02:44:21 PM »
Does either Mach3 or Mach4 have the ability to monitor the output of servo or stepper shaft encoders in order to better assure axis positional accuracy and motion control?
If not, is it correct that the Mach DRO displays operate on the basis of Mach commands rather than rely on feedback directly from the machine being controlled?
If not, is it correct that the Mach DRO displays operate on the basis of Mach commands rather than rely on feedback directly from the machine being controlled?