Guest
Show Posts
1
General Mach Discussion / How to set your own variables in a part program?
« on: February 09, 2010, 04:13:43 AM »
Hi everybody,
Since I'm new to Mach3 and already searched the forum, but couldn't find an answer, would be great if I could get some here.
Well I already did some GCode programming on some other platforms, so I wondered how I can set my own variables in a part program? Is it possible to set variables in a part program?
For example: K=3 (the variable K should be 3)
and then I use it
M=K which gives me the same result as if I would typ the command M3
Is that possible in Mach3?
Thanks for the answers, I know it should be trivial but I just can't find an answer?
best Josef
Since I'm new to Mach3 and already searched the forum, but couldn't find an answer, would be great if I could get some here.
Well I already did some GCode programming on some other platforms, so I wondered how I can set my own variables in a part program? Is it possible to set variables in a part program?
For example: K=3 (the variable K should be 3)
and then I use it
M=K which gives me the same result as if I would typ the command M3
Is that possible in Mach3?
Thanks for the answers, I know it should be trivial but I just can't find an answer?
best Josef