Guest
Show Posts
1
General Mach Discussion / new guy with 3axis CNC driver & Mach3
« on: February 06, 2010, 03:32:13 AM »
hi,
using win XP 32bit default parallel port Mach3 Mill.
here is the thing..when i press Reset button on a mach3 it turns motors on (it can run on g-code, and move about), but my mill relay output does not turns on. port is the same as motors pin is correct (when i turn it with Ative Low it turns it on..)
i went to diagnostics bar and when i push Reset it turns on the outputs of motors but Output #1 does not work..
also input switches does not work at all (autoset does not see them..).
i wonder maybe i have to install some kind off extra driver or some like that cuz' i don't think that it's the problem with port or pin settings..
Driver board from ebay..
sorry for my english.
thank you all.
using win XP 32bit default parallel port Mach3 Mill.
here is the thing..when i press Reset button on a mach3 it turns motors on (it can run on g-code, and move about), but my mill relay output does not turns on. port is the same as motors pin is correct (when i turn it with Ative Low it turns it on..)
i went to diagnostics bar and when i push Reset it turns on the outputs of motors but Output #1 does not work..
also input switches does not work at all (autoset does not see them..).
i wonder maybe i have to install some kind off extra driver or some like that cuz' i don't think that it's the problem with port or pin settings..
Driver board from ebay..
sorry for my english.
thank you all.