1
Show"N"Tell ( Your Machines) / Home made milling machine retrofit
« on: February 03, 2010, 05:11:30 PM »
Hello guys, greetings from Slovenia!
I have been reading this forum for a while now and it is really full of usefull information.
After reading about Mach3 I decided it is time to retrofit our home made milling machine.
The machine is really good mechanically but the controls are causing problems most of the time (I exaggerate a bit )
The problem is that the software was written by a local person some 15 years ago, nowadays he has no interest in the software.
Because the machine uses DC servo motors and the drives are OK I ordered Mach3 CNC Kit For 3rd Party Drives With PLC.
I allready received the package from USA!
I know that some of you out here are using product from Ajax, so I hope I will get some answers about Ajax kit!!!
So much for now, I will be posting questions in a while and I will also upload some pictures of machine.
Regards Luka
I have been reading this forum for a while now and it is really full of usefull information.
After reading about Mach3 I decided it is time to retrofit our home made milling machine.
The machine is really good mechanically but the controls are causing problems most of the time (I exaggerate a bit )
The problem is that the software was written by a local person some 15 years ago, nowadays he has no interest in the software.
Because the machine uses DC servo motors and the drives are OK I ordered Mach3 CNC Kit For 3rd Party Drives With PLC.
I allready received the package from USA!
I know that some of you out here are using product from Ajax, so I hope I will get some answers about Ajax kit!!!
So much for now, I will be posting questions in a while and I will also upload some pictures of machine.
Regards Luka