Hello Guest it is March 28, 2024, 07:26:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - KiloOne

Pages: 1
1
General Mach Discussion / Axis X encoder error
« on: January 29, 2010, 08:23:00 PM »
I have my X,Y and Z axis encoders being properly read by Mach3.

I know this because Mach3 correctly displays the coordinates reliably and each shows 0.200" per ball screw rev when turned manually. (even in the right direction).

But I can't get Mach3 to come off Reset, when I click on Reset I get the error 'Axis X encoder error'

Can't find any help on this error, does anyone have any advice?

Thanks

Pages: 1