1
General Mach Discussion / CODE NEEDED: Reading proximity Switches into MACH4 or 3
« on: November 06, 2016, 12:33:20 PM »
My ATC has TWO proximity switches INSIDE the spindle head. They are used to determine if the TOOL HOLDER is properly installed.
Does anyone have code (preferably LUA if possible) to represent reading the two proximity switches into MACH4 or 3?
Code I could use as a basis to kickoff/write modifications, so I'm not starting from scratch?
THANKS.
Does anyone have code (preferably LUA if possible) to represent reading the two proximity switches into MACH4 or 3?
Code I could use as a basis to kickoff/write modifications, so I'm not starting from scratch?
THANKS.