Guest
Show Posts
1
General Mach Discussion / Mach3Turn Canned Cycles G81-G89
« on: January 27, 2010, 05:27:04 PM »
Hi,
I have new CNC Lathe and want to use drilling cycle, but Mach3 do nothing.
I read Mach3 G code reference guide completely and try to run sample code of G81 cycle, but Mach3 not react to this code.....
I can use only G83 always and G73 with used XY work plane.
Could anybody help me? Is this some problem in Mach settings or write anything bad in g code?
What i must write to MDI or into gcode file when i want use G81 or other canned cycles for drilling a boring?
Thank You very much for every answer.
John
PS: I have Mach3 3.042.029
I have new CNC Lathe and want to use drilling cycle, but Mach3 do nothing.
I read Mach3 G code reference guide completely and try to run sample code of G81 cycle, but Mach3 not react to this code.....
I can use only G83 always and G73 with used XY work plane.
Could anybody help me? Is this some problem in Mach settings or write anything bad in g code?
What i must write to MDI or into gcode file when i want use G81 or other canned cycles for drilling a boring?
Thank You very much for every answer.
John
PS: I have Mach3 3.042.029