Topics

1

General Mach Discussion / setting up 2 machines

« on: October 14, 2007, 12:19:11 PM »

Hello I was wondering if there is a way to have the settings in Mach, saved for my old machine and then I could use a A/B printer port switch to pick my new machine with new settings?
Thanks in advance
Mark

2

General Mach Discussion / Help with scale

« on: January 16, 2007, 11:47:42 AM »

Hello, I have an issue where If I create a tool path in Artcam, and then open it in Mach3 the scale is off. For an example if ithe part is suppose to be 10" it comes up  WAY smaller and I have to scale it up.
I have been messing with it and found that if I scale up all the axis in Mach to 13% its close to the original, but not right still.
Any ideas about what Im doing wrong would be a great help. Maybe I did not set up Mach right? Im new to all this.
Thank You,
Mark