1
General Mach Discussion / Mach3 and Flashcut driver
« on: January 26, 2010, 09:07:11 AM »
Hello
I have a Sherline mill with Flashcut 3 axis cnc . I have been trying without success to get Mach3 demo version to run my mill.
I have the Flashcut driver box connected to the computer printer port.
I have been through the help videos and have been through all of the items they talked about as far as getting your motors to run.
This system has stepper motors.
Will a Flascut driver only work with its own signal box ?
Is there a video on how to check your port cable to see if it is putting out signal ?
Thanks for any help you can give.
Dave E
I have a Sherline mill with Flashcut 3 axis cnc . I have been trying without success to get Mach3 demo version to run my mill.
I have the Flashcut driver box connected to the computer printer port.
I have been through the help videos and have been through all of the items they talked about as far as getting your motors to run.
This system has stepper motors.
Will a Flascut driver only work with its own signal box ?
Is there a video on how to check your port cable to see if it is putting out signal ?
Thanks for any help you can give.
Dave E