1
General Mach Discussion / combining gcode
« on: February 22, 2012, 09:21:31 PM »
I searched manual and here for the answer. However, I cannot find one so..
I wish to combine several g codes tool paths into one batched job.
My part has drilled holes, a pocket, and an outer profile.. Right now I load each tool path for each step.
How can I combine all the tool paths into one so the job will run till complete?
Does mach3 have the ability to autoload or combine the paths?
I am not sure of the terminology used for this process.
I wish to combine several g codes tool paths into one batched job.
My part has drilled holes, a pocket, and an outer profile.. Right now I load each tool path for each step.
How can I combine all the tool paths into one so the job will run till complete?
Does mach3 have the ability to autoload or combine the paths?
I am not sure of the terminology used for this process.