Hello Guest it is October 18, 2019, 12:34:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - orangejbird

Pages: 1
1
General Mach Discussion / Plasma THC Sewing/bouncing
« on: December 11, 2012, 02:45:45 PM »
Plasma Torch moves up and down slightly about 3 times a second. Looks like it's trying to sew. Changing tip volts changes the height the bounce happens at. Bounces about 1/32"

Mach3

I'm probably missing a THC setting of some kind?
Any suggestions?

DynaCNC w/4000 series controls, Cutmaster 52.

Pages: 1