1
General Mach Discussion / How to set rebound distance after homing?
« on: March 15, 2010, 01:35:01 PM »
Hi all,
I'm struggling to get my stock MaxNC T2 lathe to home to a consistent position. My current effort is to slow down the homing speed, but that doesn't seem to give it enough bounce off of the switch to consistently clear and I often end up with the limit switch still triggering. Is there any way to set the rebound distance so that that my axis stops well clear of the switch?
I'm struggling to get my stock MaxNC T2 lathe to home to a consistent position. My current effort is to slow down the homing speed, but that doesn't seem to give it enough bounce off of the switch to consistently clear and I often end up with the limit switch still triggering. Is there any way to set the rebound distance so that that my axis stops well clear of the switch?