Guest
Show Posts
1
General Mach Discussion / Spindle wont start, keyboard jog doesnt work
« on: November 25, 2009, 09:30:53 AM »
Hi all,
I'm running a Vortech Router with mach3 software. After using the support videos, I was able to solve most of my problems. I still have two left at this point in time:
The spindle won't start. I have tried to start it manually and with the S---- M03 code, and neither will fire it up. Otherwise, the machine works so far.
I cannot get the keyboard jog feature to work. This is more of a superficial issue, but I'd like to be able to jog the cutter with the keyboard as opposed to using the TAB-mouseclick-on-arrows method.
Any ideas?
Thanks.
I'm running a Vortech Router with mach3 software. After using the support videos, I was able to solve most of my problems. I still have two left at this point in time:
The spindle won't start. I have tried to start it manually and with the S---- M03 code, and neither will fire it up. Otherwise, the machine works so far.
I cannot get the keyboard jog feature to work. This is more of a superficial issue, but I'd like to be able to jog the cutter with the keyboard as opposed to using the TAB-mouseclick-on-arrows method.
Any ideas?
Thanks.