Hello Guest it is November 28, 2021, 07:50:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - David Pace

Pages: 1
1
General Mach Discussion / direct stepper control with Max NC10wave driver
« on: November 21, 2009, 04:33:15 PM »
help!I want to control two small steppers directly from the breakout board without drivers for a micro lathe project, i have been told i need to check the Max NC-10 wave driver in the ports and pins config screen. i cannot find any literature on this function, please could someone give me some info?
David

Pages: 1