Hello Guest it is July 28, 2021, 05:39:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - the-depot

Pages: 1
1
General Mach Discussion / Control Run away
« on: November 18, 2009, 10:07:59 PM »
I am having a strange problem.  I am using XP Pro. Running a CNC router with Mach 3 I used NF wizard to program a Rectangle the control runs fine it jogs, homes and has run some of the other files "road runner" etc.  Today after programming and posting  I started the program setting the z 0 high to test the program.  The control cut three sides and then went nuts.  I jumped around in the Y and X axis in rapid moves.   The toolpath tracked the movements.  The Code looks normal.  no od rapid moves in the program. I am running a dell P4 .  What am I doing wrong.  Thank you

Pages: 1