Hello Guest it is September 18, 2019, 08:53:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jbjackson

Pages: 1
1
General Mach Discussion / Z late getting to final depth
« on: November 20, 2009, 12:01:12 PM »
Hi, Let me start out saying I'm new to Mach. I have just finished building my table and have a problem. Whenever I start to make a cut my Z axis doesn't get to it's final depth before x and y start to move. It will get there, but the first part of the cut is shallow.
Joe

Pages: 1