Hello Guest it is March 29, 2024, 07:53:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - foxcatII

Pages: 1
1
General Mach Discussion / parallel port problems
« on: November 16, 2009, 10:23:59 AM »
Hi,
I am new to the Mach3 world, but the mechanic of my CNC is almost clse to the completion, and no it is time start to work on the electronic.
My electronic (from ZAPP UK) is based on the following
UNIPORT
SY60STH86-3008 Nema 23
PM542 Microstepping Driver

Following the connection of a single axis (I am just first testing), there is no chance to have any movement from the motor. I have set, or at least I think to have done, the parallel port in accordance with the connection scheme of the UNIPORT.
When I check on the diagnostic page of  Mach3, I do not see any led flashing. Do you have any ideas what is going wrong?
Thank you.
Marco

Pages: 1