Topics

1

FAQs / Shortcut Key to Display

« on: January 23, 2010, 10:34:22 AM »

On the cutting display I keep clicking on the left mouse key that rotates the display instead of the right one to move the image. Is there a key combination to recenter or un rotated the display?

And also can I opt to not have the plasma profiles be used in the G-code?
Thanks Ken

2

FAQs / Looking for some one to make me some small gears:

« on: November 22, 2009, 01:29:46 AM »

The subject about said it all. I use electric turkey knifes in my business to cut foam. These knifes have a wormgear and a drive gear the drive gear is made out of Nylon and doesn't last very long I have a lot of samples with one side striped if anyonewould like to play with this project please let me know and I will get a hold of you off line Thanks

Ken

3

General Mach Discussion / Self Aligning Gantry

« on: November 09, 2009, 09:47:08 PM »

I have just finishing up my plasma / router table it is a 48" x 96" table with steppers on each side for the y axes each side has a homing switch connected to a board with A home and Y home can I get mach 3 to controll each motor so I can bring the gantry back into alignment each time I send it home. Right now i have Y and A slaved.

Any help would be appreciated.