1
General Mach Discussion / Motion Controller to Mach3 Problems
« on: November 09, 2009, 01:53:02 PM »
Hi I am not sure if i am posting this in the right place but here goes
I have just built a cnc engraver and am using a motion control 4 axis unit has anybody used Mach3 software to run a unit like this. I have just purchased the Mach3 software and have spent 2 days trying to get this setup to run with no success.
The steppers will only run in one direction that is when they run under test but as soon as i try to run a program the make a noise and do not run. Is there anybody who has managed to run a combination like this I would realy appreciate some help.
Thanks Stanley
I have just built a cnc engraver and am using a motion control 4 axis unit has anybody used Mach3 software to run a unit like this. I have just purchased the Mach3 software and have spent 2 days trying to get this setup to run with no success.
The steppers will only run in one direction that is when they run under test but as soon as i try to run a program the make a noise and do not run. Is there anybody who has managed to run a combination like this I would realy appreciate some help.
Thanks Stanley