1
General Mach Discussion / new hermes vanguard 5000 controlling
« on: November 04, 2009, 06:37:58 PM »
I recently picked up a new hermes vanguard 5000 i have two of the machines and a control pc but the old software is too limiting, I want to set it up with mach3. I noticed the back of the machine has a parallel connector, can I just hook this up to my pc? Has anyone messed with one of these before and maybe have some insight. I am not totally helpless with electronics but thats about it. I have working knowledge of g-code and cnc running. Please help point me in the right direction.