Topics

1

Newfangled Solutions Mach3 Wizards / NFS Wizards on Tormach

« on: October 26, 2012, 04:45:27 PM »

I put the latest Tormach version of Mach 3 on my PCNC yesterday, prior to that I copied and pasted the Wiz license to
the desktop, I then put it back in after the new install. The NFS wizards screen opens but I can't get past there?
Even with no license file they normally work but won't post code?
Will

2

General Mach Discussion / 24 volt proximity switches

« on: July 08, 2011, 03:10:15 AM »

Hi Everyone I need some help
I am converting a Chinese router from DSP controller to Mach 3 , I have a BOB and speed control board from Peter Homann as well as the 5volt power supply for these, originally the machine was fitted with SN04-N 24 volt proximity switches which have their own power supply. I want to keep these and was advised to use an Opto22 G4PB4 board and G4IDC modules as an interface between the 24 volt side and the 5volt Breakout Board.
I am not the worlds most brilliant at electronics and cant seem to get the wiring set up that I get a 24v signal in one side and 5v out the other? Can someone give me some easy to follow directions please?
Will