Hello Guest it is March 28, 2024, 08:57:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - willems

Pages: 1
1
General Mach Discussion / incorrect dimensions when inverting x axis
« on: September 14, 2010, 03:28:48 PM »
we are using the same millingmachine under two profiles
the profile 'left' with 0 of X axis left and with limits setting for motor homing on NOT inverted
the 'right' profile with 0 of X axis to the right and X axis motor homing INVERTED
now when using the same G code on the same machine in the two different profiles we become two different results
one profile with the non reversed homing all dimensions are fine and with the reversed homing all circles are ALL 1mm smaller
in the G code G40 is set the two profiles are identical (except homing direction of X axis)
can anyone help in this strange behavior (we use this method to mill at the faces of a board) 

Pages: 1