1
Third party software and hardware support forums. / Need help for probing plug in
« on: December 28, 2009, 10:36:00 AM »
Hello all,
I'am trying to test the probing plug in.
I have well understand all the concept and parameters, my probe is ok on pin15
after each movment the plug in run generate a movment that is executed but at the end of all movment.. I got the message "previous SEQ not yet completed"
it's look like the plug in is unable to get something from mach3 ?
someone get an idée ?
thks by advance
vincent
I'am trying to test the probing plug in.
I have well understand all the concept and parameters, my probe is ok on pin15
after each movment the plug in run generate a movment that is executed but at the end of all movment.. I got the message "previous SEQ not yet completed"
it's look like the plug in is unable to get something from mach3 ?
someone get an idée ?
thks by advance
vincent