Guest
Show Posts
1
General Mach Discussion / Alphacam
« on: February 04, 2010, 10:56:44 AM »
Hi
I read that I can use Fanuc post, when y load the file in the Mach3, dont see a toolpath¿?...is that correct? I´m used to Syil 4Plus Mill.
Thank in advance
Antonio
I read that I can use Fanuc post, when y load the file in the Mach3, dont see a toolpath¿?...is that correct? I´m used to Syil 4Plus Mill.
Thank in advance
Antonio