Hello Guest it is October 28, 2021, 01:11:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - mason

Pages: 1
General Mach Discussion / Quick question.
« on: October 22, 2009, 02:37:27 AM »
I am using mastercam and mach3 to run my operations. But for some reason I keep getting this error message every time I load particular codes. Current point same as end point of arc on line number #.
Can anybody help me out. I have stared at this thing for hours.


Pages: 1