Hello Guest it is November 28, 2021, 06:46:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - waynegramlich

Pages: 1
1
General Mach Discussion / Nothing to Feedhold Error Message
« on: October 06, 2009, 08:04:21 PM »
I've just started to try learn how to use a Tormach PCNC 1100 mill.  It uses Mach3 as the control software.  I stumbled upon an error message "Nothing to Feedhold" which means nothing to me.  I've searched the forums and could not find anything that really explained it to me.  It is probably something really stupid, but I'm stumped.  I can move the table around with the jog commands, but it will not run my CNC code.  Any insight would be greatly appreciated.  Thanks in advance.

Pages: 1