Guest
Show Posts
1
General Mach Discussion / Nesting troubles
« on: December 01, 2011, 12:58:52 PM »
I've done a lot of searching etc. but I still can not get the nesting to work correctly. I put M99 and CR at the bottom of the file. It's a square part with 1 holes with 3 different diameters and one outside diameter which is 0.7" deep. The code is created with the nesting wizard and I return to Mach3 run screen there are 2 parts in the table display. So far so good.
The first part runs great, but when it's done the cross hair moves to the center of the second part and again so far so good. But as soon as it gets to the center of part #2, it returns to the center of part #1 and repeats the cut on part #1.
I have not run this on the mill yet, just simulated in Mach3, version R3.043.050. Any help would be appreciated. I must be missing something really simple.
Thanks,
Leland
The first part runs great, but when it's done the cross hair moves to the center of the second part and again so far so good. But as soon as it gets to the center of part #2, it returns to the center of part #1 and repeats the cut on part #1.
I have not run this on the mill yet, just simulated in Mach3, version R3.043.050. Any help would be appreciated. I must be missing something really simple.
Thanks,
Leland