Hello Guest it is May 07, 2021, 01:20:29 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cadwiz

Pages: 1
1
General Mach Discussion / 4th axis toolpath wanders
« on: April 09, 2011, 04:21:06 PM »
Can somebody help me understand.  Got a 4th axis setup and all I've seen is adjust motor calibration to whatever you can can stand.  What does this mean?  I put a part in and try to cut and the tool path wanders around no matter what the motor settings are for a-axis.  What do I have to do to tune 4th axis?

Pages: 1