Guest
Show Posts
1
General Mach Discussion / Mach3 and mpg2 problem
« on: March 18, 2010, 11:01:12 AM »
When the mpg2 is connected it works fine except that i cant run a program. I jumps all over the place and loose steps. I can jog just fine and even cut at feed speed, but at rapid speeds it makes a very bad grinding noise and looses steps. Its similar to when your setting up servos and they are out of tune or running faster than spec. The only way i am able to fix the problem is to remove the 2nd card and mpg2. Also, when the c22 is pluged into the 2nd port the pc will hang on boot up, but works fine if i plug it in after boot.
Im figure its a conflict with the onboard para port, but not sure how to fix it.
Im figure its a conflict with the onboard para port, but not sure how to fix it.