1
General Mach Discussion / Probe and A axis problem in Mach3
« on: January 01, 2006, 03:32:57 AM »
I am using the digitizing wizard in Mach3 with the TP100 probe. My machine has the A axis as a slave to the X axis (two motors on x gantry). When I run the digitizing routine my X and A motors do not work. If I go and turn off the slave axis (A), then everything seems to work OK but only one of the motors on my gantry works (axis A). How do I use the probe with a double motor X movement (motor X and A). Hope the makes sense.
Thanks WrongWayRay (Ray Choat)
rec@alaska.net
http://www.metalcarver.com
Thanks WrongWayRay (Ray Choat)
rec@alaska.net
http://www.metalcarver.com