Hello Guest it is March 28, 2024, 05:42:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bbasiaga

Pages: 1
1
General Mach Discussion / limit switch issue
« on: August 31, 2009, 09:48:56 AM »
Hi all. I hope I'm posting in the right place. We are running a xylotex board with Mach 3. We set up travel limit switches on the x-axis and tested them. They worked fine. We then extended the wiring loop to include the y and z axis limits, and now we have a problem where every 30 seconds or so the software trips as if a limit was hit. It seems like there is a charge building or something and then finally there is enough potential that the point sees voltage. I'm curious if anyone has had a similar issue? Could it be something in the software set wrong? Could my loop of wire be too long and causing problems?

Thanks,
Brian

Pages: 1