Hello Guest it is August 17, 2022, 08:51:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - fetchy

Pages: 1
General Mach Discussion / need help with input signals!
« on: August 24, 2009, 02:42:29 AM »
I haven't got much knowledge in Mach3Mill.
So I hope you can help me to solve my problem:
I want to regulate the speed and the direction of the motors with one input signal each.
The input signal is given by a force sensor in voltage.
Is this possible?
Can you say me how I have to configurate Mach3 Mill?

Kind regards, Tine

Pages: 1