Guest
Show Posts
1
General Mach Discussion / Port 1 Pins Current State
« on: August 24, 2009, 02:59:02 PM »
Like many other posts I have read, my DRO's respond to the up and down arrows on my keyboard, but I get no motor movement. I am using the Keling package with the C10 BOB, 4030 Drivers, and 425oz motors.
I have checked ports, get no errors, rechecked wiring, etc.... I am using the motor tuning recommended on their website. I do notice though, that in the Diagnostics screen, the Port 1 Pins Current Statehas no lights lit up.
when I played with the e-stop port 15, that one pin will light up.
I will try swapping out the parallel printer cable after work, but I don't think at this point this is the problem.
Any suggestions? Different motor tuning, configuration, jumper settings, etc...?
Thanks, Jim
I have checked ports, get no errors, rechecked wiring, etc.... I am using the motor tuning recommended on their website. I do notice though, that in the Diagnostics screen, the Port 1 Pins Current Statehas no lights lit up.
when I played with the e-stop port 15, that one pin will light up.
I will try swapping out the parallel printer cable after work, but I don't think at this point this is the problem.
Any suggestions? Different motor tuning, configuration, jumper settings, etc...?
Thanks, Jim