1
General Mach Discussion / pokey55
« on: August 19, 2009, 05:28:46 AM »
Hi guys,
I am new to this forum so please excuse any variation form convection that this forum may use!
Can anyone tell me can I use the Pokey55 to drive the xyz axis from my laptop as I cannot use the lpt port, basically is this unit a motion controller?
I'm an electronics engineer so any additions that may be needed will be no problem to me, unlike linking the stepper motor to the xyz axis's!
paul
I am new to this forum so please excuse any variation form convection that this forum may use!
Can anyone tell me can I use the Pokey55 to drive the xyz axis from my laptop as I cannot use the lpt port, basically is this unit a motion controller?
I'm an electronics engineer so any additions that may be needed will be no problem to me, unlike linking the stepper motor to the xyz axis's!
paul