Topics

1

LazyCam (Beta) / z axes

« on: May 12, 2006, 02:22:00 AM »

Brian
Is it possible in lazy cam to have only one entry of the z axes per chain so that it is easier to modify the z axes in edit.
Thank You
Clay

2

General Mach Discussion / corel draw 12

« on: December 30, 2005, 08:20:07 PM »

Art
If it was posible too import a DXF file from Corel Draw 12 into Mach 3 life would be a lot easier. I have found a work around but I can't use layers with the
work around.
I save as an Autocad 10 then open up the file in Turbocad learning edition then move the file to were it should be located in Mach 3 then exit and then save
as a turbocad file. It will then load in Mach 3 DXF import.  I will send a simple file that you can look at.
Thank You
Clay