1
Forum suggestions and report forum problems. / Mach 3 and Yaskawa Servos
« on: August 17, 2009, 02:32:34 PM »
Hello,
I was looking for some suggestions. I'm fixing to build me a router machine and I have some used Yaskawa drives that I would like to use. The part # SGDA-04AP is one that I have. I have been reading all kinds of forums and there are people that say these will work with step and direction signals and some that say they wont because this is a position control drive. I was wanting to know if anyone has used these and if there is a breakoutboard that is recommended to use with Mach 3? Any info would be greatly appreciated.
Thanks
I was looking for some suggestions. I'm fixing to build me a router machine and I have some used Yaskawa drives that I would like to use. The part # SGDA-04AP is one that I have. I have been reading all kinds of forums and there are people that say these will work with step and direction signals and some that say they wont because this is a position control drive. I was wanting to know if anyone has used these and if there is a breakoutboard that is recommended to use with Mach 3? Any info would be greatly appreciated.
Thanks