Hello Guest it is August 14, 2020, 01:50:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - thenewguy

Pages: 1
1
General Mach Discussion / need to add fonts to the write wizzard
« on: August 17, 2009, 01:08:35 PM »
I searched around the site a little and only came across one topic that seemed to address this but I need to add several new fonts to the 'text engraving v4' wizard by German Bravo. I tried loading the new fonts into c:/windows/fonts and most programs will then be able to access them but this write wizard does not. The only other post I could find here said that the fonts the wizard uses arent fonts but are some sort of code that the wizard uses as a font. I need to know how to convert a normal font to be able to be used for engraving. Point me in the right direction to figure this out.

any help appreciated

Pages: 1