Topics

1

General Mach Discussion / router drive bars

« on: December 18, 2009, 09:56:33 AM »

Hello I have my cnc router built. I'm deciding on if I should have the xyz bars turned down and use a drive belt, or should i attach them straight to the nema motor shaft's. I use mach 3 software. any help is highly appricated. thanks and Merry Christmas to all

2

General Mach Discussion / NEED HELP WIRING

« on: August 21, 2009, 07:46:40 PM »

HERE IS WHAT I HAVE AND I CAN'T FIGURE IT OUT> PLEASE HELP ME WIRE THESE.

3

General Mach Discussion / cnc driver board

« on: August 14, 2009, 06:52:24 PM »

Hello

 I have my cnc router almost finished. I'm using mach 3. I have nema 23 277oz motors. can anyone tell me a goo 3 axis board and power supply for these? Thank you in advance

4

General Mach Discussion / road runner

« on: August 14, 2009, 02:02:57 PM »

Hello

 I'm very new with mach 3. I have the full version and I am trying to find the road runner file. can anyone help me with this?  Thanks in advance.