1
General Mach Discussion / G-Code rendering improperly
« on: August 12, 2009, 10:54:35 PM »
Hi All,
I tried to post this in the bugs section but it considered me a "spammer". Maybe because my text had links in it? ... Anyway
If you use this profile: http://www.c-horsesoftware.com/mach3issue/FireballV90.xml
It incorrectly renders this job: http://www.c-horsesoftware.com/mach3issue/JRC_faceplate.dnc
Here's what it should look like (this is from DeskCNC):
Here's what it looks like on Mach3:
It renders properly when I use the Mill profile that comes with the software. Any idea what's causing it?
-- Fred
I tried to post this in the bugs section but it considered me a "spammer". Maybe because my text had links in it? ... Anyway
If you use this profile: http://www.c-horsesoftware.com/mach3issue/FireballV90.xml
It incorrectly renders this job: http://www.c-horsesoftware.com/mach3issue/JRC_faceplate.dnc
Here's what it should look like (this is from DeskCNC):
Here's what it looks like on Mach3:
It renders properly when I use the Mill profile that comes with the software. Any idea what's causing it?
-- Fred