Topics

1

General Mach Discussion / THC300/Mach3 Touch off issue

« on: May 04, 2011, 06:44:10 PM »

After a reinstall of mach3 and THC300 the torch is moving out to the first cut and then moves up instead of down to touch off.  I have the motor direction set correctly and it bumps up to jog as it should. Any ideas what it is? I am using sheetcam to process gcode.

2

General Mach Discussion / Recovering from hard drive crash THC300 settings

« on: April 27, 2011, 09:39:56 PM »

I have my plasma table almost back to where it was before the crash. My last hurtle is that the torch will not fire with output1. It will fire with charge pump2 (port2Pin17). I have output 1 set as port2 pin1 and it does nothing. Any ideas how to change the torch trigger back to output 1?